DSX-LABA/MN Full Container Line Testing Module

Detailed Introduction to DSX-LABA/MN Full Container Line Testing Module Inventory in Stock
When testing the whole box line, the vast majority of people make crystal heads on both ends of the cable and then use the channel adapter DSX-CHA004S for testing. This testing method is incorrect because the maximum length of the channel link test is 100 meters, while the whole box line has 305 meters; Secondly, the testing requirements for the entire box of wires can only include the wire component, and no additional crystal heads can be added. Therefore, testing the full container line requires the DSX-5000 series to be paired with an adapter for testing the full container line, which is also our DSX-LABA/MN full container line testing module in stock. This adapter is commonly known as a speaker. DSX-LABA/MN full box line testing module.
The significance of single ended testing: For a cable manufacturer, the equipment, processes, and other conditions used to produce cables are certain and controllable. Therefore, the results of multiple single ended tests can be counted and a "correction table" can be developed. As long as the test results meet the "correction table", the entire box of cables is qualified, otherwise it is unqualified. Due to the different production equipment, processes, and environments of different manufacturers, it is impossible to achieve uniformity in the "correction table". Only cable manufacturers can obtain the "correction table" that matches their own products.
[DSX-LABA/MN] Use of DSX-5000 series 305 meter full box line test adapter:
To complete the testing of the entire box line, simply install the DSX-LABA/MN full box line testing module on the host of the DSX-5000 series tester (DSX5000 series), open the DSX-5000 series host, turn the optional button to "SETUP", enter the "Twisted Pair" menu, select the corresponding testing limit value (in the Other Limit Value column - select C6 or C5eCable Spool (LA) limit value) and cable type to perform the full box line testing. During testing, the wire ends in the box should be peeled off and inserted into the pins of the DSX-LAB/MN adapter, paying attention to the wire sequence when inserting. There is no need to worry about interference between the blue and green lines here. Normally, this will increase NEXT, but the DSX-5000 series tester and DSX-LABA/MN can suppress local NEXT interference. DSX-LABA/MN inventory in stock.

DSX-LABA/MN inventory in stock, DSX-LABA/MN testing parameters reference:
length
transmission delay
Delay Skew
resistance value
NEXT (Near End Interference)
RL (Return Loss)