Pressure type liquid level transmitterMain technical parameters
Range: 0~30m
Measurement medium: various corrosive liquids such as water, heavy and light oil, crude oil, acid and alkali
Accuracy: 0.25% F · S; 0.5% F · S (usually 0.5% FS)
H - height of liquid level to be measured, unit: m
Po - pressure on the liquid surface, in kPa
If the back chamber of the sensor is connected to the upper part of the liquid level, Po is zero, so H is approximately equal to 0.102P/p. The transmitter converts the sensed pressure signal into an electrical signal, which is proportional to the height of the liquid level.
Output: 4~20mADC
Temperature: ambient temperature 0~60 ℃, medium temperature 0~250 ℃
Power supply: 24VDC
Dustproof and moisture-proof: all-weather
Explosion proof level: EXia II CT5
Indicator header: 100% pointer header or 31/2-digit LCD display (user must specify separately when ordering)

Pressure type liquid level transmitterWorking principle of
When the sensor of the transmitter is placed at a certain position in the liquid, the pressure received by the sensor through the air duct is: P=9.807pH+Po
Among them, P represents the pressure sensed by the sensor, measured in kPa
P - Liquid level density, unit: g/cm3
Attention: The container of the tested liquid must be open to the atmosphere and cannot be sealed, otherwise the measurement results will be meaningless.

selection method