IMS-I

Allowable positions for a single reference mark (7 codes, features: R1... R5)

Due to mechanical boundary conditions, the selection of reference markers should follow the following diagram. Do not select reference markers within the range of X and Y. That is to say, for R1... R5, the possible positions are determined in such a way that they are greater than X and greater than Y. The description of the positions is given in steps of 1mm.

Example: Specification 45: R1=223mm, Rn=rail length -43mm, with protective tape and protective end cap (AK).

A small spacing of 10mm must be maintained between each reference mark.