A new type of corn single seed seeder with a three row transmission shaft,There are seven types of rows from two to eight, and the configuration can be assembled according to the needs. The accessories are as follows:

1. Trench opener: can be matched with solid, hollow trenchers, and rear corner trenchers are divided into pointed shovel and elliptical trenchers,

2. Fertilizer box: It can be equipped with V-shaped, flat bottomed, perforated, transparent plastic steel, large compartment, small compartment, double compartment, three-layer compartment, and can be driven by a motor according to demand,

3. Seed planter: It can be matched with finger clip or spoon wheel seeders as needed, as well as Tianjiang conveyor belt seeders

4. Large beam frame: divided into six different angles, it can be assembled with large tractors, medium tractors, and small tractors,

Introduction to the dual fertilizer box of corn seeder

As shown in the above figure:
1. Both the front and rear corners are equipped with solid trenchers with high hardness and no breakage. If encountering hard and destructive objects such as stones, bricks, tree roots, etc. during the sowing process, it will not have any impact on the new corn planter.
2. The seed planter is equipped with a brush inside. You can grab a handful of corn seeds with your hand and put them into the planter to use up all the corn without any holes. A planter without a brush will not block the corn, and the corn seeds will be at the lower end of the planter. A small amount of corn seeds cannot be buried by the spoon wheel, and holes will occur. Therefore, dealers need to tell the operators that a planter without a brush should put more corn seeds, and if it is not used up, it can be put out completely. Remember to sow a little more and add enough corn seeds to bury the spoon wheel, so that there are no holes
3. The seed feeding port of the seed box is located in the middle, with high, medium, and bottom on both sides of the seed box. Add a small amount of corn seeds, and the corn seeds will be concentrated in the center of the feeding port until they are used up.

1. Due to the design of the front corner trencher as a flat shovel with a slightly downward curved long angle, when sowing hard plots, the operation can be drilled into the soil by touching the ground, reducing the distance to the soil compared to old-fashioned trenchers and ensuring that every corn seed can be covered with soil.
2. The trencher is solid and will not deform or be damaged when encountering tree roots or bricks or stones during the operation process.
3. There are two pin holes, one large and one small, at the connection point with the tractor suspension, which can meet the matching needs of tractors of different heights.

The ground wheel is widened and can be fully compacted for corn seeds and fertilizers after covering with soil,Each connection of the drive shaft has an oil seal to prevent dust from entering,

All models of Shuangyin brand can change the seeding of various crops by replacing the spoon wheel, achieving multi-purpose use of one machine. It is a multifunctional corn planter, and the spoon wheel can be consulted with the manufacturer. The following picture shows various spoon wheels for seeding various crops