Overview of multifunctional slurry melting machine products:

1、 XL-50Multi functional slurry melting machineMain technical parameters and characteristics:

1Temperature control 37 ℃± 1 ℃

2Temperature control accuracy ± 0.5 ℃

3Digital temperature display, microcomputer temperature control.

4Heating power. ≤ 1000W

5Thawing time, ≤ 10min

6:Dissolve less than 8 bags (100-200ml)

7:There are 8 immovable stainless steel thawing blue pieces

8Equipped with an automatic dual arm swing system that swings back and forth 60 times per minute or automatic frequency modulation.

2、 XL-50Multi functional slurry melting machineprecautions

1Normally set the water temperature, it can be turned on for a long time. When using it, turn on the swing switch, set the frequency, and it will automatically swing. After use, turn off the swing switch to save electricity and reduce mechanical wear.

2Before use, be sure to add water to the water level line and avoid dry burning to protect the heating tube. As the startup time increases, the water in the water tank gradually evaporates. Please check the water level at any time (add water and replace it). Ensure that the machine is operating normally.

3.Set temperature: Press the SET key to set or view the temperature set point. Press the SET key once to start flashing the character, indicating that the instrument has entered the set state. Press the △ key to increase the set value, and press the △ or ▽ key to quickly change the data. Press the SET key again to return the instrument to normal working state. Once the temperature setting is complete, the heating indicator light will turn on.

4.Pre setting: Press the SET button for 3 seconds to enter the inner layer parameter setting state of the instrument. The first parameter that appears and flashes is the stop advance amount. The advance amount parameter should be carefully adjusted to reduce temperature overshoot. When the instrument controls the heating output, it will cut off heating in advance. When the temperature drops below the advance amount, it will start heating again. The output (relay) will not work within the set value and advance amount range, which can reduce the number of relay actions and extend the service life of the relay. Example: If the set value is 50.0 ℃ and the advance amount is 0.5, the instrument control will add

When the temperature reaches 49.5.0, the relay releases, and when the temperature drops to 50.0 ℃ -0.5 ℃=49.5 ℃, the relay closes again. The larger the advance amount, the fewer times the relay will act, and if the advance amount is too large, it will reduce the control accuracy. After adjusting the advance parameter, press the SET button for 3 seconds to return the instrument to its working state. (Note: Pre setting is specifically set to prevent excessive temperature surge after heating stops, and generally does not require modification).

5.Error correction: When confirming that the value displayed on the instrument is not the correct measurement value, the displayed value can be corrected. Press the SET button for 3 seconds to enter the deep menu of the instrument panel. The first parameter that appears and flashes is E00, which is the advance amount. Press the SET button again to display the flashing parameter, which is the error correction parameter. Use the up and down keys to modify this parameter. The range of error correction is correct, and the instrument is corrected to be incorrect. To reach -9.9 ℃ to+9.9 ℃, press the SET button again after the correction is complete to exit. The correction value of the instrument is 0.0 when it leaves the factory.