rule grid

inside Rong

TSQJ-060

studio dimensions

600×800×1200mm

(Depth x Width x Height)

Dimensions approximately

780*1140+Control box width 210*1940mm+Motor height 270mm

(Depth x Width x Height)

material rack

8Block mesh board

Heating power:

9KW

Circulating fan:

1100W * 1 piece

bottom

4 casters

Clean parameters

Equipped with high temperature resistant and efficient filters,The filter is composed of a 304 stainless steel shell and aluminum foil spacers. canReplace with Cleanable，High temperature resistance of 250 degrees, cleanliness: efficient filtration 99.99%

Lord want skill technique ginseng number

On site environmental conditions

temperature5-40℃ Relative humidity: not greater than85% Suitable for indoor use

There is no strong vibration or airflow around No corrosive gases or chemicals present

Non drying flammable and explosive materials

Equipment Composition

Composed of furnace body, hot air circulation system, electric heating system, intake and exhaust system, circuit control system, etc

electricity source

3N+PE 380V 50Hz

Temperature range for use

Room temperature~200 ℃ (adjustable arbitrarily)

thickness of insulation layer

100K grade high-density aluminum silicate fiber insulation, insulation layer thickness 90MM

stove body be unify knot constitute

Opening method

Front double door of furnace body.(The door lock adopts chrome plated sheep horn handle and steel hinge)

Furnace shell

Q235After rust prevention treatment, cold-rolled steel plates are sprayed with acrylic self drying paint

Furnace inner liner

201 stainless steel plate thickness 1.0mm

drum wind be unify

air supply mode

Studio hot air supply method: strong pressure vertical and horizontal air supply(Left side air outlet, right side return air)

blower motor

High temperature resistant long shaft motor specifically designed for curing furnaces, with a noise level of65dBbelow

Blast power

1400 revolutions,1100W fan with multi wing high air volume centrifugal silent impeller

Installation position of motor

Installed externally at the top of the furnace, the long axis extends into the air duct at the top of the working room through the insulation layer

enter\\\\exhaust system

intake valve

Top fan base, diameter 60MM

exhaust valve

One manual exhaust valve with a diameter of 100MM is installed in front of the top (adjustable according to the required exhaust volume). The supplier shall reserve flange interfaces and provide external exhaust pipes according to the actual situation in the workshop.

electricity control be unify

control manufacture cabinet

Adopting an independent control cabinet for control, the surface of the control cabinet is treated with spraying and painting. Located on the left side of the front of the oven. Separating from the box is beneficial for protecting the heat dissipation of electrical components.

Lord control table

Digital display intelligent instrument XGQ-A2100FAutomatic temperature control, constant temperature and beltPIDAdjust. Control accuracy ±1℃.

Overtemperature protection instrument

Overtemperature protection: When the main temperature control meter fails and the temperature inside the box exceeds the specified temperature, the overtemperature protection instrument will automatically cut off heating, and the fan will not stop running to help dissipate heat.

Time setting device:

HS48S-99.99 timing device, with a maximum adjustable time of 9999H during actual setting. It can be manually/automatically switched on and off. When the temperature reaches the set temperature, the timer starts. When the set time is reached, the heating power is cut off, and the fan does not stop rotating, helping to dissipate heat inside the box.

electrical components

Adopting domestic and foreign famous brands, such as Chint, Omron, etc

heating control

Suzhou Integrated ElectronicsSSRSolid state relay contactless power regulation,

Protect system configuration

Motor protection, short circuit protection