detailed description

Introduction to slot mixer manufacturer: Maintenance and principle introduction of small mixer? Analysis of slot type mixer manufacturers: Some small mixers use a single propeller with a straight shaft for mixing, and the viewpoint planning of the blades on the single propeller is extremely reasonable and wonderful. When the single propeller rotates, the material rolls up and down, and the blades pass through the material, causing a certain pushing force on both sides of the mixing slot, so that the material in any corner of the mixing slot cannot be stopped, thereby ensuring uniform mixing of the material. Manufacturer's instructions for slot type mixer: If the reducer of a small mixer is frequently used, it should be replaced with new oil every three months. When replacing, the reducer should be cleaned and then filled with new oil. The bearing cover end of the mixing reducer is connected to the movable part of the shaft and blade, and the shaft is equipped with a smooth oil cup. During use, a butter gun is used to add butter 1-2 times per work shift. Check the mechanical parts 1-2 times a month, including the worm gear, worm gear, bearings, oil seals, etc. Check if the rolling is flexible and if the fasteners are loose. If any abnormal situations are found, they should be dealt with in a timely manner.
The small mixer adopts sealing methods such as end face sealing, regulating sealing nuts, and compensating for axial pressure. Reminder from the manufacturer of the trough mixer: If a small mixer produces abnormal vibrations or abnormal noises during use, it should be stopped immediately for inspection. Electrical control parts should be kept clean and active, and any problems should be promptly corrected. When assembling and dismantling the mixing slurry, it should be dismantled gently, installed steadily, and placed gently to avoid deformation and damage. After use, the residual materials in all parts of the machine should be cleaned. If the machine is not in use for a long time, it must be wiped and cleaned completely. The surface of the parts should be coated with anti rust oil and covered with a tarpaulin. If a small mixer is found to cause abnormal vibrations or make abnormal noises during operation, it should be stopped immediately for inspection. Electrical control parts should be kept clean and active, and any problems should be promptly corrected. When assembling and dismantling the mixing slurry, it should be dismantled gently, installed steadily, and placed gently to avoid deformation and damage. After use, the residual materials in all parts of the machine should be cleaned. If the machine is not in use for a long time, it must be wiped and cleaned completely. The surface of the parts should be coated with anti rust oil and covered with a tarpaulin. In addition to the functions of continuous mixing, jog mixing, and active material pouring, the small mixer now has a timed mixing function. Before mixing, the timer can be set arbitrarily, and the machine will automatically stop at that time. Not only does it save energy, but it can also prevent safety accidents caused by the machine not stopping even after the operator leaves the machine. The original model of this machine had a cast iron base painted with paint. Nowadays, the new model produced uses stainless steel to close all parts that come into contact with materials and the shell, which meets GMP requirements.

Previous article:Introduction to examples of using food shredders

Next article:The purpose and characteristics of CH series slot mixer