Zhengzhou Weisheng Electronic Technology Co., Ltd
Home>Products>MP402 Combustible Gas Sensor
Firm Information
  • Transaction Level
    VIP member
  • Contact
  • Phone
    186-9582-0325
  • Address
    299 Jinsuo Road, Zhengzhou High tech Development Zone, Henan Province
Contact Now
MP402 Combustible Gas Sensor
MP402 Combustible Gas Sensor
Product details
product details

The MP402 combustible gas sensor adopts a multi-layer thick film manufacturing process, with heaters and metal oxide semiconductor gas sensing layers respectively made on both sides of a micro Al2O3 ceramic substrate, and packaged in a metal shell. When there is a detected gas in the ambient air, the conductivity of the sensor changes. The higher the concentration of the gas, the higher the conductivity of the sensor. A simple circuit can be used to convert this change in conductivity into an output signal corresponding to the gas concentration.

Sensor characteristics

This product has good sensitivity to methane over a wide concentration range, with excellent anti-interference ability, low power consumption, fast response recovery, good stability, long lifespan, low cost, and simple driving circuit.

Main applications

1. Combustible gas leak monitoring devices and fire/safety detection systems used in households, factories, and commercial premises.

2. Combustible gas leak alarm and gas leak detector.

TECHNICAL INDEX

PRODUCT MODEL MP402
product type Flat semiconductor sensor
Standard packaging Metal encapsulation
Detect gas Methane, natural gas, biogas
Detect concentration 300-10000ppm (methane, natural gas)
standard
circuit
condition
loop voltage VC ≤24V DC
heating voltage VH 5.0V±0.1V AC or DC
load resistance RL adjustable
standard
test
condition
Lower Qi
Min Yuan
Item Special
sexually
heating resistor RH 85 Ω± 15 Ω (room temperature)
Heating power consumption PH ≤350mW
Sensitive body
resistance
RS 1K Ω~20K Ω (in 5000ppm methane)
sensitivity S Rs (in air)/Rs (in 5000ppm methane) ≥ 5
Concentration slope α ≤0.6(R5000ppm/R1000ppmMethane)
Standard testing conditions Temperature and humidity 20℃±2℃; 55%±5%RH
Standard Test Circuit VC:5.0V±0.1V;
VH:5.0V±0.1V
Warm-up time Not less than 48 hours

Online inquiry
  • Contacts
  • Company
  • Telephone
  • Email
  • WeChat
  • Verification Code
  • Message Content

Successful operation!

Successful operation!

Successful operation!