During the forklift repair process in Luoyang, it is important to pay attention to safety, prepare for forklift repairs, and perform regular maintenance operations during the repair process

1. To ensure safety, when lifting the vehicle, it should be parked on a level surface and the front and rear wheels should be in braking mode.

2. Support the vehicle on the chassis frame, use a jack to press the support point against the axle and frame, lift the vehicle up and perform maintenance work.

3. Before carrying out maintenance work, the grounding wire should be removed from the battery to reduce the risk of wire damage and burnout caused by short circuits.

4. Cover the body, seats, and floor with protective covers to prevent damage and contamination.

5. Due to the fact that brake fluid and antifreeze can easily damage painted surfaces, appropriate care must be taken during handling.

6. It is necessary to use prescribed tools and equipment for effective and reliable maintenance operations.

7. Used open-end pins, gaskets, O-rings, oil seals, locking washers, and self-locking nuts must be discarded and new ones should be prepared for reassembly. If these parts are reused, they cannot maintain their normal function.

8. To ensure both correct and smooth reassembly operations, disassembled parts should be neatly grouped and stored.

9. Before inspection and reassembly, the parts should be cleaned. In addition, the oil ports and other parts should be blown clean with compressed air to confirm that there are no blockages in these areas.

10. Before assembly, the rotating and sliding surfaces of the parts must be lubricated with oil or grease.

11. When necessary, sealant should be used on the sealing gasket to prevent leakage.

12. Fully understand the torque specifications of all bolts and nuts.

13. After the maintenance work is completed, it is necessary to check for any missing maintenance items.

14. Be sure to pay attention to safety when lifting the vehicle. Please use a jack or stopper. Confirm the surrounding safety conditions. The rope used for lifting heavy objects should have sufficient safety factor. Before using power tools to disassemble components, ensure that bolts, nuts, pipes, and wiring harnesses are completely separated.

15. When carrying heavy items, use certain equipment or tools and do not move them by hand.

16. When repairing hydraulic systems and other dust-proof components, please use clean tools in a clean and dust-proof area.

17. Before inspecting or welding electrical system components, make sure to remove the leads from the battery terminals. (First remove the negative pole, then remove the positive pole.)

18. Be careful to prevent oil, gas, and flammable materials from entering the work area. Organize the disassembled components and tools.

19. Warning signs should be hung on the engine or control handle for maintenance time. It is not allowed to disassemble components during engine operation.

20. Do not stand directly below the fork or fork rack. Use a stopper to block the equipment and fork frame during maintenance.

21. Arrange maintenance tools in order, conduct regular inspections, and use them correctly.