1. Performance characteristics:

The float control switch is a switch that can adjust the liquid level in a bucket, tank, or well. It can be automatically adjusted, easy to operate, convenient to install, reliable, maintenance free, non-toxic and environmentally friendly. It has a resistance effect on sewage and is widely used in water tanks in households, factories, mines, acid and alkali tanks, barrels, tanks, irrigation containers, etc.

2. Technical parameters:

Rated current: Voltage: 10 (8A) 250V-10 (4) A380V;

Rated power: 1KW;

Working temperature: -10 ° C~90 ° C;

Working pressure: 1 atmosphere;

Working lifespan:>5000

Lead length: 4M (special lengths can be customized according to requirements).

3. Installation and wiring methods:

Use brown and black wires:

When the float is at the lower liquid level, the contact is in a connected state.

When the float is at the upper liquid level, the contact point is in a closed state.

Use brown and blue wires:

When the float is at the upper liquid level, the contact is in a connected state.

When the float is at the lower liquid level, the contact point is not connected.

Unused wires (insulated).

It is recommended to use a voltage of 24V for the float level controller.

4. Installation method of heavy hammer:

After inserting the cable of the float switch through the concave circular hole in the center of the heavy hammer, gently push the heavy hammer to make the plastic ring embedded above the circular hole fall off due to the pushing force of the cable head. If necessary, you can also use a screwdriver to remove this plastic ring. Then put the detached plastic ring on the cable to fix the weight hammer as desired and set the position of the liquid.

Gently push the heavy hammer to pull out the cable until the center of the hammer grips the plastic ring. As long as the heavy hammer lightly grips the plastic ring, it will not slip off. If the plastic ring is damaged or lost, it can be replaced by a bare copper wire of the same diameter that is fastened into the cable.

The heavy hammer is a required accessory attached.

Please pull the cable directly to the control box and avoid using intermediate connectors as much as possible.

If there is no other choice but to have a connector, do not immerse the cable connector in liquid.

Ordering Notice:

The order needs to specify the model, quantity, etc. of the required dissolved air flotation balls.