1、 Summary:

The outer shell of the organizational crusher is made of aluminum alloy casting, and the crushing cup and blade are stamped and formed from stainless steel plates. The speed is adjustable and equipped with a timing device.

2、 Technical parameters:

Power supply voltage: 220V 50HZ

Adjustable speed range: 12000 revolutions per minute

Motor power: 120W

Capacity: 1000ml, converted to 100g solid and 800ml liquid

3、 Usage:

Firstly, lift the connecting joint between the motor and the crushing rod upwards so that the crushing rod can be removed. Take out the crushing cup and add the desired substance and solution to the crushing cup. Install the cup and rod as they are (with the lower end of the rod aligned with the axis) and cover the cup tightly. Check the timing

Turn the knob to the ON (normally open) position or the time position you need to specify, turn the speed control knob counterclockwise to the ON position, turn on the power, turn on the power switch, the indicator light will be on, and then turn the speed control knob clockwise to the speed you need, mix evenly and stir

For use, medium to low speed is sufficient. When crushing plants, high speed should be used as there is noise during high-speed crushing. When replacing the solution, the power should be cut off and the above operation should be repeated.

4、 Attention:

This machine adopts a three eye safety socket. Before use, the ground wire must be connected properly. When working, the machine should be placed on a flat and solid table to prevent vibration. When crushing at high speed, the cup cover should be held down by hand. When it is difficult to slide the connecting shaft up and down, one to two drops of engine oil should be injected to lubricate it. It is forbidden to crush hard materials such as bones and minerals. This machine uses a series motor, and its carbon brush is generally used for about 500 hours. It should be replaced in a timely manner to avoid the phenomenon of the commutator being worn out due to the polishing of the carbon brush. After the machine is completed, the crushing cup should be washed and inverted before installation, and placed in a dry and ventilated place

Changzhou Meixiang Instrument Co., Ltd. (formerly known as Jintan Meixiang Instrument Co., Ltd.) is a manufacturer in Jiangsu Province that integrates instrument design, production, manufacturing, sales, and production.