Four link automatic lifting electric mixer product overview:

JJ-4Digital six link synchronous electric mixerIt has the characteristics of beauty, advanced structure, high precision, low noise, easy operation, high work efficiency, and corrosion resistance. Can be applied to the design of water purification equipment, simulation testing, and experimental testing of alum consumption in water treatment departments; Research on the coagulation effect of various coagulants; The comparison of the effects of various coagulants is an indispensable high-performance equipment for departments such as scientific research, chemical engineering, teaching, printing and dyeing, and environmental wastewater treatment.

1 JJ-4Digital six link synchronous electric mixerstructural principle

This machine adopts220V 50HzAC power supply. Using an electronic speed regulating motor, it drives six mixing shafts to work simultaneously through synchronous belt pulley rotation. Adjusting the electronic speed controller can achieve stepless transmission and digital speed measurement.

The mixing shaft, slurry plate, and synchronous pulley of this machine are made of stainless steel, engineering plastic, and aluminum alloy materials, respectively, which have high strength, wear resistance, corrosion resistance, and low mechanical rotation noise.

II JJ-4Digital six link synchronous electric mixerMain technical skills

1、 tuneSpeed range:01800turn/divideSpeed digital display

2、 Power supply voltage: AC220V 50Hz

3、 Timing range:0-120Split (or normally open)

4、 The maximum mixing capacity of each mixing shaft1000Mix six liquid samples simultaneously with six stirring shafts in milliliters.

5、 The noise level is not higher than62dB

III JJ-4Digital six link synchronous electric mixeroperating steps

1、 Before operation, it is necessary to be familiar with this operating procedure.

2、 Press the "Power" button, the power indicator light will turn on, set the timer to the normally open position or time it according to the desired working time, and the motor will start working. Adjust the speed control knob to the desired speed.

3、 After the experiment is completed, turn off the power switch and the motor will stop working.

4、 Cut off the power supply.

four JJ-4Digital six link synchronous electric mixerMaintenance and Precautions

1、 Six precision components of the mixing shaft system should not be horizontally pulled or bumped during operation to avoid deformation. When pulling up or pressing down the mixing shaft, it should be stopped from rotating or carried out at low speed, and excessive force should not be applied.

2、 When the machine leaves the factory, the axial alignment of the six mixing shafts is not greater than0.2Millimeters. During use, if the mixing effect of the six shafts is uneven, it is allowed to adjust the two end faces of the mixing plate appropriately.

The power supply voltage should be stable, and units with high requirements for speed stability should be equipped with a regulated power supply.

The six link lifting mixer is widely used in laboratories of various universities, environmental protection, scientific research, epidemic prevention, petroleum, food and other units, and is a precision instrument commonly used by laboratory personnel. And JJ-4A has automatic lifting and automatic on/off cycle.