The FP reinforced polypropylene centrifugal pumps produced by Chongqing Zhongbai Pump Industry all adopt mechanical seals and introduce international advanced processes and technical formulas, using CFR-PP (reinforced polypropylene) and modified ABS (engineering plastic) aspumpThe material is corrosion-resistant in the same seriescentrifugal pumpThe product fully demonstrates its advanced structure, light weight, small size, and long service life, and is widely used in chemical, food, pharmaceutical, papermaking, environmental protection, water treatment and other departments to transport corrosive liquids such as acids, alkalis, and salts.

The 101, 102, 103, 104, and 105 corrosion-resistant plastic pump series single suction direct coupled plastic centrifugal pump is a small plastic pump with advanced structure, small volume, light weight, low power consumption, acid and alkali resistance, good sealing, and easy maintenance. Widely used for transporting corrosive liquids such as acids, alkalis, and salts, ideal products for chemical, light industry, and waste treatment. Among them, the 104 type adopts 220V voltage and can be used for household selection.

1. Plastic pumps should be installed horizontally, and the pump body should not follow the weight of the pipeline. For special requirements for vertical installation, the motor must be facing upwards.

2. The pump body must be filled with water before use. When the suction liquid level is higher than the pump axis line, open the suction pipeline valve before starting. If the suction liquid level is lower than the pump axis line, the pipeline needs to be equipped with a bottom valve.

3. Before starting the motor, check whether its rotation direction is consistent with the pump direction mark.

4. The conveyed medium and temperature should be within the allowable range of the pump material. The operating temperature of plastic pumps should not exceed 60 ℃, the temperature rise of the motor should not exceed 75 ℃, and the ambient temperature should be less than 40 ℃.

5. No no-load operation is allowed.

FP Reinforced Polypropylene Centrifugal Pump - Structural Description


1. Pump casing 2, impeller shaft assembly 3, mechanical seal 4, pump cover 5, motor

1. Plastic pumps should be installed horizontally, and the pump body should not bear the weight of the pipeline. For special requirements for vertical installation, the motor must be facing upwards.

2. Add water to the pump body before use. When the suction liquid level is higher than the axis line, open the suction pipeline valve before starting. If the suction liquid level is lower than the pump axis line, the pipeline needs to be equipped with a bottom valve.

3. Before starting the motor, check whether its rotation direction is consistent with the pump direction mark.

4. The conveyed medium and temperature should be within the allowable range of the pump material (see attached table). Centrifugal pumps should be used at temperatures FP ≤ 80 ℃ and FS ≤ 60 ℃. The temperature rise of the motor should not exceed 80 ℃, and the ambient temperature should be less than 40 ℃.

5. No no-load operation is allowed.

No information available at the moment