SP-LDEElectroplating wastewater flowmeter(Acid washing wastewater)It is an induction instrument that measures the volume flow rate of conductive medium inside a tube based on Faraday's law of electromagnetic induction. It adopts embedded technology of single-chip microcomputer to achieve digital excitation, and adopts CAN fieldbus on the electromagnetic flowmeter.
SP-LDEElectroplating wastewater flowmeter (anti-corrosion type)While meeting on-site display requirements, it can also output 4-20mA current signals for recording, regulation, and control purposes. It has been widely used in industrial technology and management departments such as chemical, environmental protection, metallurgy, pharmaceuticals, papermaking, and water supply and drainage.
SP-LDEElectroplating wastewaterflowmeter(Sewage treatment)In addition to measuring the flow rate of general conductive liquids, it can also measure the volumetric flow rate of liquid-solid two-phase flow, high viscosity liquid flow, and salt, strong acid, and strong alkali liquids.

Precautions for on-site installation:
1. It should be installed at the lower and vertically upward positions of the horizontal pipeline, avoiding installation at the highest point and vertically downward position on the pipeline.
2. Should be installed at the rising point of the pipeline

3. When installing an open discharge pipeline, it should be installed at the lower part of the pipeline.

4. If the pipeline drop exceeds 5m, install an exhaust valve downstream of the sensor.

5. Sensors must not be installed at the inlet and outlet of the pump, but rather at the outlet of the pump.

6. There should be at least a 10 * D (D is the inner diameter of the flowmeter) straight pipe section in front of the flowmeter, and a 5 * D straight pipe section behind it.