Two types of three-phase electronic reactive energy meters, DTSX6111 three-phase four wire and DSSX6111 three-phase three wire, are produced using integrated circuits through SMT technology. The structural design is reasonable, the manufacturing process is advanced, and compared with traditional energy meters, the three-phase electronic active energy meter has high measurement accuracy and reliable performance.

2 Main functions and features

·Total electricity meter indicator or LCD display.

·Active positive energy metering.

·A-phase, B-phase, C-phase voltage loss detection indication.

·A passive pulse output.

Note: According to user requirements, an LCD display can be equipped with a 485 communication interface.

3 main technical indicators

·Basic error: (when balancing loads)

load current	power factor	Basic error%
		Level 1.0	Level 2.0
0.05Ib	1.0	±1.5	±2.5
0.1Ib—Imax	1.0	±1.0	±2.0
0.1 Ib	0.5 Sensory	±1.5	±2.5
0.2Ib—Imax	0.5 Capacity	±1.0	±2.0

·Model specifications

model	DTSX6111 three-phase four wire	DSSX6111 three-phase three wire	Calibration current	rated frequency
rated voltage	3×220V/380V	3×380V	1.5（6）A、5（20）A 10（40）A、20（80）A、30（100）A	50Hz
	3×57.7V/100V	3×100V	1.5（6）A、3（6）A	50Hz

·Starting current: 1.0 level 0.4% Ib calibration current, 2.0 level 0.5% Ib calibration current

Constant current.

·Stealth: Designed with anti creep logic.

·Voltage line power consumption: ≤ 2W/10VA.

·Working voltage range: 0.8Un~1.2Un

·Working temperature: -10 ° C~45 ° C

·Extreme temperature: -20 ° C~55 ° C

·The annual average humidity is ≤ 75%.

·Weight: Approximately 1.2Kg

·Dimensions: 230mm × 145mm × 70mm

4 Installation and use

The electric energy meter should be installed inside the indoor or outdoor meter box, and the installation base should be fixed on a sturdy and fire-resistant wall. There should be no corrosive gases in the air. The specific installation dimensions are shown in Appendix Figure 1 (recommended installation height is 1.8m); If the machine is severely impacted or the shell is significantly damaged due to falling from a high altitude during the installation process, please do not install or power it on, and contact the supplier as soon as possible.

The electric energy meter should be wired according to the wiring diagram, preferably using copper wire or copper wire connectors.

5 Packaging and transportation storage

The transportation and unpacking of this table should not be subjected to severe impact. The storage location should have an ambient temperature of 0 ℃ -60 ℃, a relative humidity of no more than 85%, and should not contain corrosive gases in the air.

The electric energy meter should be stored in the warehouse, and under the original packaging conditions, the stacking height should not exceed five layers. Electric energy meters with unpacked inner packaging should not be stored.

6 Wiring diagram