VIP member
CHG series flow-through oven
The cross flow oven has a greater drying capacity than the flat flow oven, and the thickness of each layer of material loaded is more than three times
Product details
|
product overview |
|||||||||||||||||||||||||||||||||
 Each cycle of hot air is filtered through sub high efficiency or high-efficiency filters, which can effectively prevent the deterioration of materials carried in the air during the reheating process and the contamination of drugs. It fully complies with the "GMP" pharmaceutical production standards.The cross flow oven has a greater drying capacity than the flat flow oven, and the thickness of each layer of material loaded is more than three times that of the flat flow oven. The cross flow oven has a large drying area, high efficiency, and a capacity 3-6 times larger than the flat flow oven, with lower cost. Suitable for drying various granular and block shaped items. Easy to operate, easy to clean and replace, with low risk of malfunctions. Both the air inlet and outlet are equipped with air filters, which will not contaminate the dried materials and affect their quality. The heating source for the oven can be steam or electric heating. |
|||||||||||||||||||||||||||||||||
|
Working principle |
|||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||
 In traditional horizontal flow box dryers, the airflow only flows on the surface of the material, which has the disadvantages of low heat transfer coefficient, poor heat utilization rate, long drying time of the material, and cannot fully comply with the "GMP" pharmaceutical production standards due to structural defects. To overcome the above shortcomings. Our factory has designed and developed a flow-through box dryer based on advanced foreign technology. The working principle is shown in the figure:This machine uses a fan to filter a portion of the fresh air through primary, secondary, and tertiary filters. Reaching a purification level of 100000, the air is heated to a certain temperature through a steam heat exchanger. After purifying the hot air through a filter, it is then divided into each layer by the left side splitter plate, allowing the hot air to evenly pass through each layer of the dried material. After the moist air is drawn out from the inclined air duct under the dryer, a portion of it is discharged outside the oven by a centrifugal fan. The other part of the air continues to circulate and heat up. Achieve the purpose of drying. |
|||||||||||||||||||||||||||||||||
|
Technical Parameter |
|||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||
Online inquiry
-
Contacts
-
Company
-
Telephone
-
Email
-
WeChat
-
Verification Code
-
Message Content
-