ACLT type cyclone dust collector

Due to the small size of the cyclone particles and high airflow velocity in the ACLT type cyclone dust collector, if there is no wear-resistant lining on the inner surface, the wear of the cyclone cylinder wall will be quite severe. Therefore, before starting or during major maintenance of the multi tube cyclone dust collector, it is important to focus on checking the wear of the cyclone elements in the ACLT type cyclone dust collector, and promptly replace or repair the perforated cyclone elements

Product Details

Due to the small size of the cyclone particles and high airflow velocity in the ACLT type cyclone dust collector, if there is no wear-resistant lining on the inner surface, the wear of the cyclone cylinder wall will be quite severe. Therefore, before starting or during major maintenance of the multi tube cyclone dust collector, it is important to focus on checking the wear of the cyclone sub of the ACLT type cyclone dust collector, replacing or repairing perforated cyclone sub in a timely manner, and checking the airtightness of each part to prevent short circuits of smoke and dust and reduce dust removal efficiency. During the operation of the ACLT cyclone dust collector, the operating conditions of the ACLT cyclone dust collector can be basically determined by observing the changes in pressure difference force before and after the dust collector and the color of the exhaust gas. For example: 1. The exhaust smoke is dark and the resistance of the equipment increases, which may be caused by excessive dust accumulation at the lower part of the outer cylinder of the cyclone. 2. The exhaust smoke is dark in color, and the resistance of the ACLT type cyclone dust collector is reduced. This may be due to perforation caused by wear of the outer or inner cylinder of the cyclone, inadequate airtightness of the outer or inner cylinder, and wear of the rotating impeller. Generally, the diameter of ACLT type cyclone dust collectors is relatively large, and some cyclone dust collectors are lined with wear-resistant materials. Therefore, in addition to maintaining the flexibility and airtightness of the ash discharge device, the ACLT type cyclone dust collector should also inspect and repair the wear and tear of the wear-resistant lining. The repaired lining should maintain a smooth surface and the net clearance size inside the equipment should remain unchanged. The ACLT type cyclone dust collector is composed of three parts: the cyclone body, the ash hopper, and the volute (or air cap). According to the number of cylinders, there are five combinations: single cylinder, double cylinder, three cylinder, four cylinder, six cylinder, etc. Each combination has two types of air outlet: ACLT type cyclone dust collector Type I horizontal air outlet and Type II (upper air outlet). For Type I twin tube combination, there are two types of combinations: center inlet and outlet air and side inlet and outlet air. Type I single tube and triple tube only have side inlet and outlet air, while four tube and six tube combination only have center inlet and outlet air. For various combinations of ACLT cyclone dust collector, any of the inlet positions in Type I of ACLT cyclone dust collector can be used. This ACLT cyclone dust collector has the characteristics of low resistance, high dust removal efficiency, large processing air volume, stable performance, small footprint, simple structure, practicality and low cost. Suitable for coarse and intermediate dust purification in mechanical processing, metallurgical building materials, and mining operations.