Today, Sichuan United Punching and Cutting Machine Manufacturer will share its technical specifications with you. Interested parties, let's take a look together.

1. Before driving, check whether the transmission components, connecting screws, and pin shafts of the punching and shearing machine are loose. Is the electrical grounding intact.

2. Before starting work, lubricate all parts and test drive for two to three minutes. Only when there are no issues can work begin.

3. Overloading is not allowed, and punching and cutting of quenched steel are strictly prohibited.

4. When working, gloves and labor protection equipment should be worn properly, and sandals and slippers are strictly prohibited.

5. When punching and cutting, it is necessary to regularly add oil to the punching tool to prevent it from tilting up and down.

6. Pay attention to finger safety when feeding, especially when the sheet metal is rushed When the rear presser foot cannot press the sheet metal, it is forbidden to punch and cut.

7. It is strictly prohibited to disassemble or calibrate cutting blades and dies while driving. Do not forcefully strike the punching die, cutting blade, and other components.

8. Strictly control the specification range of the sheet metal, and it is strictly prohibited to cut or punch when exceeding it.

9. The workplace must not pile up other items or large amounts of flushing materials, and parking must be done during adjustments and cleaning.

10. After the work is completed, stop and cut off the power in a timely manner, and clean up the site.

So how to operate the joint punching and shearing machine? Here are its operating steps:

1. Check the power supply condition, ensure stable voltage, no phase loss, and ensure that the leakage protector and air switch are intact.

2. Connect the wires, open the wiring cabinet of the combined punching and shearing machine, connect the wires, and close the cabinet door.

3. After powering on, press the foot switch and the machine will not move. Swap the power cord and check if the emergency stop switch is turned on.

4. Connect the foot pedal switch.

5. During work, pay attention to turning off the power every time the mold is replaced

6. After completing the work, turn off the switch, turn off the main power switch, disconnect the power cord, and clean up any debris.

Through so much summary, I hope it can be helpful to everyone. If you have any further questions, please feel free to contact us at any time.