The POV-1000 clean oven has a wide range of applications: it is suitable for baking items with chemical gases and food processing industries, removing substrate stress, curing ink, drying paint films, etc. Widely used in precision baking, drying, tempering, preheating, shaping, and processing of electronics, motors, communications, electroplating, plastics, hardware chemicals, food, printing, pharmaceuticals, PC boards, powders, impregnation, spraying, glass, ceramics, wood building materials, and more.

The air circulation system adopts a dual motor horizontal circulation air supply method, with uniform and efficient air circulation. The air source is driven by a circulating air supply motor (using a contactless switch) to drive the wind wheel (Φ 230) through an electric heater, and then the hot air is sent out through an air duct to the interior of the oven. The used air is then sucked into the air duct to become the air source for further circulation and heating. Ensure indoor temperature uniformity. When the temperature value fluctuates due to the action of opening and closing the door, the air supply circulation system can quickly restore the operating temperature value.

1. After connecting the power supply, the heating switch can be turned on. For the clean oven, turn the temperature setting dial to the desired working temperature value, set the temperature "Set Measure" switch to "Set", adjust the temperature setting knob to the desired working temperature, and then turn the "Set Measure" switch to "Measure". At this point, the temperature inside the oven starts to rise and the green light is on.
2. After the temperature reaches, it can be kept constant for a certain period of time according to the needs of the experiment. During this process, the clean oven can be automatically controlled by a temperature controller without the need for manual management.
3. When the clean oven is kept at a constant temperature, the high-temperature switch of the electric constant temperature blower drying oven should be turned off, leaving only one set of electric heaters working to avoid excessive power and affecting the constant temperature accuracy. When the working temperature is less than 150 ℃, only one set of heaters needs to work, and the high-temperature switch should be turned off.
4. When the temperature reaches the desired working temperature, adjust it to turn off the green light, and then make slight adjustments until the green light returns on. The point where the indicator light alternately turns on and off is the constant temperature point. At this point, you can adjust the knob to turn off the green light and keep it constant. It is likely that the temperature will continue to rise even when the constant temperature is reached, which is due to the influence of residual heat.